Froling TX 150 - Blowing in Pellets for a Store with Pellet Screw; Blowing in Pellets for a Partially Emptied Store with Stirrer

Operating the system
Filling/ refilling the store with fuel
Fröling Heizkessel- und Behälterbau Ges.m.b.H
 Industriestraße 12  A-4710 Grieskirchen Page 23
Tel +43 (0) 7248 606-0  Fax +43 (0) 7248 606-600  info@froeling.com  www.froeling.com B 067 03 11_en
3
3.2.3 Blowing in pellets for a store with pellet screw
For systems with a pellet screw, the boiler must be in “OFF” status when
the store is filled. The under-pressure from the blowing could bring
smoke back into the store.
 Switch off the boiler using the standby key ( ) and allow it to cool
down for at least two hours.
 Close all openings to the store to seal out dust
 Blow the fuel into the store
3.2.4 Blowing in pellets for a partially emptied store with stirrer
If there is still sufficient fuel in the store (the head of the stirrer is
completely covered with fuel), the store can be filled:
 Switch off the boiler using the standby key ( ) and allow it to cool
down for at least two hours.
 Close all openings to the store to seal out dust
 Blow the fuel into the store