Froling TX 150 - Faults with Fault Message; Procedure for Fault Messages; Acknowledging a Fault Message

Troubleshooting
Faults with fault message
Fröling Heizkessel- und Behälterbau Ges.m.b.H
 Industriestraße 12  A-4710 Grieskirchen Page 39
Tel +43 (0) 7248 606-0  Fax +43 (0) 7248 606-600  info@froeling.com  www.froeling.com B 067 03 11_en
5
5.3 Faults with fault message
If a fault message is pending:
 Status LED (4.1) indicates the type of fault:
- Orange flashing: warning
- Red flashing: error or alarm
 The relevant fault message is shown on the display (4.2)
The term “fault” is a collective term for warnings, errors and alarms.
The boiler reacts differently to the three types of message:
WARNING In case of warnings the boiler initially continues controlled
operation, giving the option of resolving the error quickly to
prevent a shutdown.
ERROR The boiler follows shutdown procedure and remains in “Boiler
off” status until the problem is resolved.
ALARM An alarm triggers a system emergency stop. The boiler shuts
down immediately, the heating circuit controller and pumps
remain active.
5.3.1 Procedure for fault messages
The procedure in case of fault message, the causes for faults and
procedure for troubleshooting are described in the operating instructions
for the boiler controller:
 See the operating instructions for the Lambdatronic H 3200
5.3.2 Acknowledging a fault message
Trace and remove the fault and then:
 Press the enter key ( )
 Status LED constant or flashing green light (depending on
operating status)
- Green constant: boiler switched on
- Green flashing: boiler switched off
4.1
4.2