TEMP−CONT
Output:3−5.2V
Input:110V, 220V / 230V / 240V
-12-
9. Adjustments
(1) Heater temperature
Set the knob to position 3 or 4
Adjust the heater temperature by selecting
a value between 1 and 6. Choose the suitable
conditions of the machine. If the heater
temperature, bearing in mind the environmental
or reduce the heater-knob value until
seal will not be obtained. Gradually increase
temperature is too high or too low, a proper
obtainging an optimum seal.
To Next Page
Loading...
