lock at the same time and the strap will
(1) Turn on the switch (make a 90-degree
clockwise turn). The front door will
be automatically fed into the
7. How to Operate
8. Recommend for Trouble-free
Operation
accumulator box. If you want to open
the front door, turn off the switch first
(make a 90-degree counterclockwise
turn).
door without risk. (See drawing below)
The operator can now open the front
(2) Wait for about 3 minutes until
the heater element has reached its
required operating temperature.
(3) Place a package on the center
of the strapping head. Push the start
switch 1 (P7), and the package
is automatically strapped. The
strapping operation is repeated if the
start switch is pushed again.
(4) After operation, turn off the
power supply switch.
(1) Make sure to turn off the power supply
switch, when maintenance and/or exchange
of strap coil is required.
(2) Pull the strap out of the Accumulator Box
and rewind it on the Reel Unit to prevent
cambering, if the machine will not
be used for long periods of time.
(3) In order to change the strap width, use
the strap conversion kit which is sold
as an option.
(4) When the electric plug receptacle has
to be changed, check the revolving
direction of motor.(P9 NO. 15 )(Only 3PH).
(5) Always keep the machine clean,
especially by removing dust and strap
fluff in the vicinity of the sealing head
and heater unit.
(6) Do not use extension cords.
-11-
To Next Page
Loading...
