Options
Options
NOTE!
A DIN rail is provided in order to mount
accessory electrical devices including,
but not limited to, overcurrent protec-
tion, metering, radio or cellular modem.
Maximum size for mounting of all devices
is 4 w x 4.75 l x 2.59 inches. The installer
takes responsibility for any undesired
effect on the inverter by installing an elec-
trical device in this area. Caution should
be taken when installing a device that may
output significant amounts of heat or radio
interference. Always ensure that the
device does not inhibit the inverter from
closing and sealing properly. Any ques-
tions about device eligibility should be dir-
ected toward technical support.
OPTION 'Shade-
Cover'
- Use the ShadeCover when the
inverter is exposed to direct sunlight
- Use 4 screws for proper mounting
61
EN-US
To Next Page
Loading...
