Service codes
when the drive
units are
engaged
("engaged" calib-
ration)
St1 | E 16
Push-pull calibration was interrupted: Quick-stop was activated by pressing
the torch trigger.
Repeat push-pull calibration
Cause:
Remedy:
St2 | E 7
"Push-pull calibration - open-circuit" has not been carried out
Carry out "push-pull calibration - open-circuit"
Cause:
Remedy:
St2 | E 8
At minimum wire feed speed, the wire-feed unit motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St2 | E 9
At minimum wire feed speed, the motor of the push-pull unit does not
deliver any actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St2 | E 10
At minimum wire feed speed, the motor current of the wire-feed unit motor is
outside the permitted range. Possible reasons are disengaged wire-feed
unit motors or wire feed problems.
Engage the drive units of both wire-feed unit motors, arrange the hosepack
in as straight a line as possible; check the inner liner for kinks or soiling;
check the contact pressure on the 2-roller or 4-roller drive of the push-pull
unit. Repeat the push-pull calibration. If the error message re-appears: Con-
tact After-Sales Service.
Cause:
Remedy:
St2 | E 11
At minimum wire feed speed, the motor current of the push-pull unit is out-
side the permitted range. Possible reasons are disengaged wire-feed unit
motors or wire feed problems.
Engage the drive units of both wire-feed unit motors, arrange the hosepack
in as straight a line as possible; check the inner liner for kinks or soiling;
check the contact pressure on the 2-roller or 4-roller drive of the push-pull
unit. Repeat the push-pull calibration. If the error message re-appears: Con-
tact After-Sales Service.
Cause:
Remedy:
St2 | E 12
At maximum wire feed speed, the wire-feed motor does not deliver any
actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause:
Remedy:
St2 | E 13
At maximum wire feed speed, the motor of the push-pull unit does not
deliver any actual rotational speed value.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service (faulty actual-value pick-up)
Cause:
Remedy:
168
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
