Fronius CMT 4000 Advanced User Manual

Start-up
Safety
WARNING!
An electric shock can be fatal.
If the power source is connected to the mains electricity supply during installation, there
is a high risk of very serious injury and damage.
▶
Before carrying out any work on the device make sure that the power source mains
switch is in the "O" position
▶
Before carrying out any work on the device make sure that the power source is
unplugged from the mains
WARNING!
Danger from electrical current due to electrically conductive dust in the device.
This can result in serious injury and damage to property.
▶
Only operate the device with an air filter fitted. The air filter is a very important safety
device for adhering to the IP 23 protection class.
Remarks on the
cooling unit
We recommend using an FK 4000 R cooling unit for the following applications and situ-
ations:
- TS 4000 / 5000, TPS 3200 / 4000 / 5000 power sources
- JobMaster welding torch
- Push-pull welding torch
- Robot welding
- Hosepacks over 5 m long
- MIG/MAG pulse synergic welding
- In general, where welding is performed in higher power ranges
The cooling unit is powered from the power source. The cooling unit is ready for opera-
tion when the mains switch of the power source is in the - I - position.
More information on the cooling unit can be found in the operating instructions for the
cooling unit.
Information on
system compon-
ents
The steps and activities described below include references to various system compon-
ents, including:
- Trolleys
- Cooling units
- Wire-feed unit holders
- Wire-feed units
- Interconnecting hosepacks
- Welding torches
- etc.
For more detailed information about installing and connecting the system components,
please refer to the appropriate operating instructions.
80
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044

Fronius CMT 4000 Advanced Specifications

General

Brand	Fronius
Model	CMT 4000 Advanced
Category	AC Power Distribution
Language	English