Other tasks
1
Connect the wirefeeding hose
2
Establish a ground (earth) connection between the workpiece and power source
3
Connect the gas cylinder
4
Connect the RCU 5000i remote control
5
Make the connection to the robot control
Preparing the
wire-feed unit
Carry out the following steps in accordance with the wire-feed unit operating instructions:
1
Insert the feed rollers in the wire-feed unit
2
Insert the wirespool or basket-type spool with adapter in the wire-feed unit
3
Feed in the wire electrode
4
Set the contact pressure
5
Adjust the brake
94
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
