Before installation and initial operation
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this equip-
ment and all system components.
Intended use The device is intended exclusively for wirefeeding with TIG welding in combina-
tion with Fronius system components.
Any other use does not constitute proper use.
The manufacturer shall not be held liable for any damage resulting from improp-
er use.
Intended use also means
-
Reading these Operating Instructions in their entirety
-
Following all instructions and safety rules in these Operating Instructions
-
Carrying out all the specified inspection and maintenance work
Setup regula-
tions
WARNING!
Danger from devices falling or toppling over.
This can result in severe personal injury and damage to property.
▶
Set up all system components, upright brackets, and trolleys so that they are
stable on a flat and solid surface.
▶
When using a swivel pin holder, always ensure that the wirefeeder is firmly
seated.
The wirefeeder has been tested according to protection class IP 23. This means:
-
Protection against the penetration of solid foreign bodies with a diameter of
more than 12.5 mm (0.49 in.)
-
Protection against spraywater at any angle up to 60° from the vertical
The wirefeeder can be set up and operated outdoors in accordance with protec-
tion class IP23. Direct moisture (e.g., from rain) must be avoided.
23
EN-US
To Next Page
Loading...
