Fronius Primo 4.0-1 - The Basic Menu; General; Accessing the Basic Menu

40
The Basic menu
General The Basic menu is used to set the following parameters, which are important for installing
and operating the inverter:
Accessing the
Basic menu
The Basic menu appears.
Use the "Plus" and "Minus" keys To select the desired entry
Press the "Enter" key to open the desired menu item
Press the "Esc" key to exit the Basic menu
- DC operating mode
- Fixed voltage
- MPPT1 / MPPT2 start voltage
- USB logbook
- Event counter
- Grounding mode / grounding monitor-
ing
- Insulation settings
- TOTAL reset
Press the "Menu" key
The menu level appears.
Press the unassigned "Menu / Esc" key
5 times
"Access Code" is displayed in the "CODE" menu;
the first digit starts flashing.
Enter the code 22742: Use the "Plus" and
"Minus" keys to select a value for the
first digit of the code
Press "Enter"
The second digit flashes.
Repeat steps 3 and 4 for the second, third,
fourth and fifth digits of the access code un-
til...
the selected code starts flashing.
Press "Enter"
1
2
3
4
Access Code
5
6
7
8
9