Fronius Primo GEN24 3.0 Plus - Explanation of Footnotes

Fronius Primo GEN24 4.6 / 4.6 Plus 5.0 / 5.0 Plus 6.0 / 6.0 Plus
Voltage level of digital inputs
low: min. 0 V–max. 1.8 V
high: min. 4.5 V–max. 28.8 V
Input currents of digital inputs
depending on the input voltage;
input resistance = 70 kOhm
Total power for digital output
(internal supply)
6 W at 12 V (USB not connected)
Power per digital output
(external supply)
1 A at >12.5 V-24 V
(max. 3 A in total)
Datalogger/web server Integrated
Explanation of
footnotes
1) The values stated are defaults; the inverter is configured specifically to suit the
requirements of the relevant country.
2) Depending on the country setup or device-specific settings
(ind. = inductive; cap. = capacitive).
3) Maximum current from a defective solar module to all other solar modules.
4) Guaranteed by the electrical configuration of the inverter.
5) For backup power mode (PV Point) without battery, a minimum voltage of 150 V
is required.
6) Current peak when switching on the inverter.
7) The sum of the nominal output power per phase must not exceed the nominal
output power of the inverter.
142