Fronius RI FB PRO/i - Bus Module IP Address Management; Displaying the IP Address; Deleting IP Settings and Device Names

Assignment of the Bus Module IP Address
Assignment of
the Bus Module
IP Address
In the case of ProfiNet, the assign-
ment of the IP address, the subnet
mask, and the default gateway is carri-
ed out by the master. A device name is
also assigned to the interface by the
master.
Therefore the IP address cannot be set
via the DIP switch.
The communication takes place via the
IP address assigned by the master.
Displaying the
Bus Module IP
Address
The IP address of the bus module assigned by the master can be viewed on the
website of the power source. Proceed as follows in order to do this.
Note down the IP address of the power source used:
1
On the power source control panel, select "Presets"
2
On the power source control panel, select "System"
3
On the power source control panel, select "Information"
4
Note down the displayed IP address (example: 10.5.72.13)
Access website of the power source in the internet browser:
5
Connect computer with the network of the power source
6
Enter the IP address of the power source in the search bar of the Internet
browser and confirm
7
Enter standard user name (admin) and password (admin)
-
The website of the power source is displayed
Display IP address of the bus module:
8
On the power source website, select the "RI FB PRO/i" tab
9
The current IP address is displayed under the "Fieldbus configuration" point.
For example: 192.168.0.12
Deleting IP Set-
tings and Device
Names
The two options listed below are available for the deletion of the IP settings and
the device name.
Using the DIP switch:
1
Switch all positions on the DIP switch to OFF (position 1–6)
2
Restart interface
(disconnect power supply and then reconnect again)
On the power source website:
1
Select the "RI FB PRO/i" tab on the power source website
27
EN-US