3
Installing the
Mounting Brack-
et on a Mast or
Beam
For installation of the inverter on a
mast or beam, Fronius recommends
using the "Pole clamp" (order no.
SZ 2584.000) mast mounting kit from
Rittal GmbH.
The kit can be used to mount the in-
verter on round or rectangular masts
with the following diameters: Æ from
40 to 190 mm (round mast), ÿ from 50
to 150 mm (rectangular mast)
Attaching the
mounting brack-
et to a metal car-
rier
NOTE!
When mounted on metal supports, the inverter must not be exposed to rainwa-
ter or splashing water from the rear.
Provide suitable rainwater protection or splash water protection.
The mounting bracket must be secured in at least four places.
17
EN-US
To Next Page
Loading...
