Using for the first time
Using the Invert-
er for the First
Time
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in severe personal injury and damage to property.
▶
Only qualified staff are authorized to commission the inverter and only with-
in the scope of the respective technical regulations.
▶
Read the Installation Instructions and Operating Instructions before install-
ation and commissioning.
When starting up the inverter for the first time, various setup settings must be
selected.
If setup is stopped before it is completed, it can be started again via an AC reset.
An AC reset can be carried out by switching the automatic circuit breaker off
and on again.
The country setup can only be set when starting the inverter for the first time. If
the country setup needs to be changed at a later date, contact your technical
support.
1
S
e
l
e
c
t
C
o
u
n
t
r
y
1
2
50 Hz
International 50 Hz
2
* Country setup examples
The available country setups may change during a software update. Therefore, the following list may
not exactly match the display on the inverter.
Setups:
Symo 208 – 240
240N (with NL-Mon)
240 (without NL-Mon)
208N (with NL-Mon)
208 (without NL-Mon)
220N (with NL-Mon)
220 (without NL-Mon)
50 HZ
50 HN (with NL-Mon)
BR N (Brazil 220 V with NL-
Mon)
BR (Brazil 220 V without NL-
Mon)
HI1 (Hawaii 240 V with NL-Mon)
HI2 (Hawaii 208 V with NL-Mon)
Symo 208 – 240
MG1N* (Microgrid 240V with
NL-Mon)
MG1P* (Microgrid 240 V
without NL-Mon)
MG2N* (Microgrid 220V
without NL-Mon)
MG3N* (Microgrid 208 V
without NL-Mon)
MG3P* (Microgrid 208 V
without NL-Mon)
Symo 480
480N (with NL-Mon)
440N (with NL-Mon)
50HN (with NL-Mon)
CAL3 (California 480 V with
NL-Mon)
HI3 (Hawaii with NL-Mon)
MG5N* (Microgrid 240 V with
NL-Mon)
MG6* (Microgrid)
59
EN-US
To Next Page
Loading...
