Options
Options
NOTE!
A DIN rail is provided in order to
mount accessory electrical devices in-
cluding, but not limited to, overcur-
rent protection, metering, radio or cel-
lular modem.
Maximum size for mounting of all
devices is 4 w x 4.75 l x 2.59 inches.
The installer takes responsibility for
any undesired effect on the inverter by
installing an electrical device in this
area. Caution should be taken when in-
stalling a device that may output signi-
ficant amounts of heat or radio inter-
ference. Always ensure that the device
does not inhibit the inverter from clos-
ing and sealing properly. Any questions
about device eligibility should be direc-
ted toward technical support.
OPTION 'Shade-
Cover'
-
Use the ShadeCover when the in-
verter is exposed to direct sunlight
-
Use 4 screws for proper mounting
67
EN-US
To Next Page
Loading...
