Fronius TPS 5000 MV - Front Panel - Controls (CMT)

13 SEP 12
/ Battery Charging Systems / Welding Technology / Solar Electronics
Adjustment Dial
Adjustment DialAdjustment Dial
Adjustment Dial
Used to change the
value of a parameter or
setting.
Mode Selection
Mode Selection Mode Selection
Mode Selection
Buttons (
Buttons (Buttons (
Buttons ( up/down ⁄
⁄⁄
⁄
Used to change the
welding process of the
power source.
Trigger Selection Buttons (
Trigger Selection Buttons (Trigger Selection Buttons (
Trigger Selection Buttons ( up/down ⁄
⁄⁄
⁄
Used to changed the type of trigger setting for the
welding torch.
Material Selection Buttons (
Material Selection Buttons (Material Selection Buttons (
Material Selection Buttons ( up/down ⁄
⁄⁄
⁄
Used to select the shielding gas and filler metal to
be used during the welding process.
Diameter Selection Button
Diameter Selection ButtonDiameter Selection Button
Diameter Selection Button
Used to select the diameter of the filler metal to be
used during the welding process.
Store Button
Store ButtonStore Button
Store Button
Used in conjunction with
other buttons to get into
various other menus. Can
also be used to exit any
menu.
Purge Button
Purge ButtonPurge Button
Purge Button
Used to test the gas flow.
One press will allow gas
flow for 30s, a second
press will stop the flow.
Inch Forward Button
Inch Forward ButtonInch Forward Button
Inch Forward Button
Used to inch the filler wire
forward through the torch
without gas or current flow.
Parameter Selection Button
Parameter Selection ButtonParameter Selection Button
Parameter Selection Button
Used to determine what welding parameter will be
displayed on the RIGHT 3-digit display (arc-length
correction, dynamic, welding voltage, or job
number⁄
Parameter Selection Button
Parameter Selection ButtonParameter Selection Button
Parameter Selection Button
Used to determine what welding parameter will be
displayed on the LEFT 3 digit display (sheet
thickness, welding current, wire-feed speed, or drive
current⁄.
Keylock Switch (
Keylock Switch (Keylock Switch (
Keylock Switch ( if equipped ⁄
⁄⁄
⁄
Used to lock and unlock the front panel control,
limiting access to who can change welding settings.
-
--
- 45
45 45
45 -
--
-
Use and Operation
Front Panel – Controls (CMT)