Fronius TPS 5000 MV - Select a Synergic Line; Checking Software

13 SEP 12
/ Battery Charging Systems / Welding Technology / Solar Electronics
Step 1
Step 1Step 1
Step 1: Choose the desired filler metal wire diameter
Step 2
Step 2Step 2
Step 2: Choose the desired shield gas/filler metal
combination.
Step 3
Step 3Step 3
Step 3: Choose the desired trigger type.
Step 4
Step 4Step 4
Step 4: Choose the desired welding mode.
Select a Synergic Line
Select a Synergic LineSelect a Synergic Line
Select a Synergic Line
1
11
1
2
22
2
3
33
3
4
44
4
Checking Software
Checking SoftwareChecking Software
Checking Software
Step 1
Step 1Step 1
Step 1: Press and hold the STORE button and then press
the MATERIAL SELECTION button. Release
both buttons. One of four numbers will appear.
UST Firmware:
UST Firmware: UST Firmware:
UST Firmware: 4.25.016 (sample number⁄
Welding Database:
Welding Database: Welding Database:
Welding Database: 03.0139 (sample number⁄
SR41 Firmware:
SR41 Firmware: SR41 Firmware:
SR41 Firmware: A2.02.02 (sample number⁄
Arc Hours:
Arc Hours: Arc Hours:
Arc Hours: 00131.1 (sample number⁄
Synergic Line:
Synergic Line: Synergic Line:
Synergic Line: r0209 (sample number⁄
The machine may enter any of the four codes above,
but will cycle through in the same order.
Step 2
Step 2Step 2
Step 2: Use the MATERIAL SELECTION buttons to cycle
through the software codes.
Step 3
Step 3Step 3
Step 3: Press and release the STORE button to return to
the main welding screen.
2
22
2
1 / 3
1 / 31 / 3
1 / 3
-
--
- 48
48 48
48 -
--
-
Processes
Use and Operation