13 SEP 12
/ Battery Charging Systems / Welding Technology / Solar Electronics
Interface
Major Signals
Standard Mode: This allows the power source to weld using the synergic mode.
Pulse-Synergic Mode: This allows the power source to weld using the pulse-synergic mode.
Job Mode: This allows the power source to weld in job mode using one or more jobs specified by the robot.
Parameter Selection: Set-up mode for operator to make weld changes. Use caution when in this mode.
Manual Mode: This allows the power source to be controlled using analog inputs. There are NO job/program options.
CC/CV Mode: This allows the power source to be operated in a constant current or constant voltage mode.
TIG Mode: This allows the power source to be operated in TIG mode.
CMT/Special Process: This allows the power source to weld using CMT or a special process.
Bit 0 (X2:6⁄
Bit 0 (X2:6⁄Bit 0 (X2:6⁄
Bit 0 (X2:6⁄ Bit 1 (X8:1⁄
Bit 1 (X8:1⁄Bit 1 (X8:1⁄
Bit 1 (X8:1⁄ Bit 2 (X8:2⁄
Bit 2 (X8:2⁄Bit 2 (X8:2⁄
Bit 2 (X8:2⁄ Dec
DecDec
Dec Hex
HexHex
Hex
Standard Mode
LOW LOW LOW 0 0
Pulse-Synergic Mode
HIGH LOW LOW 1 1
Job Mode
LOW HIGH LOW 2 2
Parameter Selection (internal mode⁄
HIGH HIGH LOW 3 3
Manual
HIGH HIGH LOW 4 4
CC/CV
HIGH LOW HIGH 5 5
TIG
LOW HIGH HIGH 6 6
CMT/Special Process
HIGH HIGH HIGH 7 7
-
--
- 81
81 81
81 -
--
-
To Next Page
Loading...
