Fronius TransPocket 180 - Transpocket 150 Controls, Connections and Mechanical Components

TransPocket 150
controls, con-
nections and
mechanical com-
ponents
(2)
(3)
(4)
(1)
(7)
(6)
(5)
(8)
(1) Control panel
(2) (-) current socket
with bayonet latch
(3) TMC connection (TIG Multi Connector)
TransPocket 150 RC only - for connecting a remote control
After connecting a remote control to the power source
-
‘rc‘ appears on the power source display
-
the welding current can only be adjusted using the remote control
(4) (+) current socket
with bayonet latch
(5) Carrying strap
(6) Cable strap
for holding the mains cable and the welding power-leads
Do not use to move the device!
(7) Mains switch
(8) Air filter
Use of the current connections during manual metal arc welding (depending on
electrode type):
-
(+) current socket for electrode holder or grounding cable
-
(-) current socket for electrode holder or grounding cable
Use of the current connections during TIG welding:
-
(+) current socket for grounding cable
-
(-) current socket for welding torch
23
EN