36
Before installation and commissioning
Safety
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
► Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
► Do not use the functions described here until you have fully read and understood all of
the Operating Instructions for the system components, in particular the safety rules.
WARNING!
An electric shock can be fatal.
If the power source is connected to the mains electricity supply during installation, there is
a high risk of very serious injury and damage.
► Before carrying out any work on the device make sure that the power source mains
switch is in the "O" position
► Before carrying out any work on the device make sure that the power source is un-
plugged from the mains
Utilisation for in-
tended purpose
only
The power source may only be used for MIG/MAG and MMA welding.
Any other form of usage is deemed "not in accordance with the intended purpose".
The manufacturer shall not be held liable for any damages arising from such usage.
Utilisation in accordance with the "intended purpose" also comprises
- following all the information in the operating instructions
- carrying out all the specified inspection and servicing work
Setup regulations The device is tested to IP 23, meaning:
- protection against penetration by solid foreign bodies with diameters > 12 mm (0.49
in.)
- protection against water sprayed directly at any angle up to 60° from the vertical
The device can be set up and operated outdoors in accordance with degree of protection
IP 23.
Avoid direct wetting (e.g. from rain).
WARNING!
If one of these machines topples over or falls it could cause serious or even fatal
injury.
Place device on a solid, level surface in such a way that it remains stable.
CAUTION!
Electroconductive metallic dust may damage the device.
The air filter is a very important safety feature for achieving IP 23. Always fit the air filter
when operating the device.
To Next Page
Loading...
