18
Note! When connecting the
welding torch, check that
- all connections are connected
properly
- all cables, leads and hose-
packs are undamaged and
correctly insulated.
Connecting MIG/
MAG manual
welding torch
Connecting up
the gas cylinder
Warning! A welding machine that topples over can easily kill someone. See to
it that you place it on an even, firm floor in such a way that it stands firmly. Do
NOT fit a 50l gas cylinder to the following welding machines:
- VS 3400/4000 compact system with no inserted wirespool or fitted
FK 3000
- VS 3400-2 separated version
- VS 4000-2/5000-2 separated version with no inserted wirespool or
fitted FK 3000
1. Stand the gas cylinder on the floor of
the trolley and secure it by fixing the
securing chain around a point in the
top third of the cylinder - but never
around the neck of the cylinder
2. Connect the gas cylinder:
- Take off the protective cap from
the gas cylinder
- Briefly turn the gas-cylinder valve
anticlockwise, to blow off any dust
and dirt
- Inspect the seal on the pressure
regulator
- Screw the pressure regulator onto
the gas cylinder and tighten it
- Attach the gas hose to the pressu-
re regulator
Fig.25 Fixing the gas cylinder on the trolley
Connecting the welding torch/connecting the gas cy-
linder
To Next Page
Loading...
