Fronius WF 25i Case D200 - General; Device Concept; Warning Notices on the Device

21
EN
General
Device concept
WF 25i Case D200
The WF 25i Case D200 / WF 25i Case
D300 wire-feed unit is contained in a fully
sealed plastic housing and is suitable for
wirespools with max. diameter 200 mm
(7.87 in.) / 300 mm (11.81 in.).
The standard 4-roller drive has good wire-
feeding properties. The wire-feed unit is
also suitable for long hosepacks.
Warning notices
on the device
NOTE! The wire-feed unit is fitted with safety symbols and a rating plate. The
safety symbols and rating plate must not be removed or painted over. The safety
symbols warn against operating the equipment incorrectly, as this may result in
serious injury and damage.
40,0006,3035
Caution: Parts may be at welding
voltage
Attention: Les pièces peuvent être
à la tension de soudage
1 - 25 m/min 40-984 ipm
360A/100% 450A/60% 500A/40%I
2
1.2 AI
11
U 11
60 V
U
12 I 12 0.5 A24 V
IEC 60 974-5/-10 Cl.A IP 23
www.fronius.com
Ser.No.:
Part No.: