42
Connecting the interconnecting hosepack and MIG/
MAG welding torches
Safety
General informa-
tion
The wire-feed unit is connected to the power source using the interconnecting hosepack.
Connecting the
interconnecting
hosepack
1 2
* Only if the coolant connections are fitted in the wirefeeder and when using a water-
cooled welding torch
3
WARNING! An electric shock can be fatal. Before starting the work described be-
low:
- turn the power source mains switch to the "O" position
- disconnect the power source from the mains
- ensure that the power source remains disconnected from the mains until all
work has been completed
CAUTION! Risk of injury and damage from loose connections. All cables, lines
and hosepacks must be properly secured, undamaged, insulated and adequately
dimensioned at all times.
1
*
*
2
3
To Next Page
Loading...
