Fronius WF 25i Case D200 - Optional Control Panels

31
EN
Optional control panels
Safety
General
OPT/i WF POT
control panel
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. All the functions described may only be used by trained and qualified
personnel. Do not use the functions described until you have thoroughly read and
understood the following documents:
- this document
- all the operating instructions for the system components, especially the safe-
ty rules
NOTE! Optional control panels are available for the WF 25i Case D200 and WF
25i Case D300 wire-feed units. The design and position of the control panels are
identical for both wire-feed units.
No. Function
(1) OPT/i WF POT control panel
(2) - Setting the welding power
(during MIG/MAG synergic weld-
ing - Standard, Puls, PMC, LSC)
- Setting the wire feed speed
(during MIG/MAG standard man-
ual welding)
No. Function
(3) - Correcting the arc length
(during MIG/MAG synergic welding - Standard, Puls, PMC, LSC)
- = shorter arc length
0 = neutral arc length
+ = longer arc length
- Setting the welding voltage
(during MIG/MAG standard manual welding)
(3)
(1)
(2)