23
EN
Crane transport The wirefeeder can be transported by crane using its handle.
The maximum load-bearing capacity of the handle is dependent upon the model:
- D200: 15 kg (33.07 lb.)
- D300: 35 kg (77.16 lb.)
Before transporting by crane:
- feed out the wire electrode, remove the wirespool
- disconnect the torch hosepack and interconnecting hosepack from the wirefeeder
- if present, unplug the coolant connections
WARNING! Falling equipment can cause death or serious injury.
- Only use a suitable lifting tackle when transporting devices by crane (e.g. belt
with round slings)
- The lifting tackle must be undamaged and in perfect condition
- Always attach the lifting tackle to both ends of the handle - see diagram be-
low
- Do not transport any other loads by the handle apart from the wirefeeder itself
- Do not hang from the wirefeeder as it is being transported
To Next Page
Loading...
