41
EN
Before installation and commissioning
Safety
Proper use The device is intended exclusively for wire feeding in MIG/MAG welding in conjunction with
Fronius system components.
Utilisation for any other purpose, or in any other manner, shall be deemed to be not in ac-
cordance with the intended purpose.
The manufacturer shall not be held liable for any damages arising from such usage.
Proper use includes:
- carefully reading these operating instructions
- following all the instructions and safety rules in these operating instructions
- performing all stipulated inspection and maintenance work
Setup regulations
WARNING! Incorrect operation or shoddy workmanship can cause serious injury
or damage. All work described in this document must only be carried out by
trained and qualified personnel. All functions described in this document must
only be used by trained and qualified personnel. Do not carry out any of the work
or use any of the functions described until you have fully read and understood the
following documents:
- this document
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! If one of these devices falls or topples over, it could cause serious or
even fatal injury. Place all system components, upright consoles and trolleys on
a solid, level surface in such a way that they remain stable. If a swivel pin holder
is being used, always make sure that the wire-feed unit is seated securely on the
swivel pin of the swivel pin holder.
The device is tested to IP 23 protection, meaning:
- protection against penetration by solid foreign bodies with diameters exceeding 12.5
mm (0.49 in.).
- protection against direct sprays of water at any angle up to 60° from the vertical
The device can be set up and operated outdoors in accordance with IP23. Avoid direct
wetting (e.g. from rain).
To Next Page
Loading...
