Frymaster BIH52 Series - Page 81

4-10
ITEM PART # COMPONENT
Fluecap Assemblies
1 910-2414 BIH152/MH152 (standard)
2 900-7921 BIH152/MH152 (for units with Cap-N-Splash)
3 823-2544 BIH252/MH252 (standard)
4 900-7926 BIH252/MH252 (for units with Cap-N-Splash)
5 823-2545 BIH352/MH352 (standard)
6 900-7927 BIH352/MH352 (for units with Cap-N-Splash)
7 823-2546 BIH452/MH452 (standard)
8 900-7928 BIH452/MH452 (for units with Cap-N-Splash)
9 823-2887 BIH552/MH552 (standard)
* 900-2447 Flue Clip Support
Old
Cap-N-Splash Assemblies (See Note)
10 823-2276 BIH152/MH152 (New 823-3066) Kit 826-1223
11 823-2277 BIH252/MH252 (New 823-3067) Kit 826-1218
12 823-2833 JBIH252 (Japanese units)
13 823-2278 BIH352/MH352 (New 823-3068) Kit 826-1217
14 823-2879 JBIH352 (Japanese units)
* 823-2279 BIH452 (New 823-3070) Kit 826-1216
* ----- BIH552 (New 823-3069)
Standoffs
15 900-2406 BIH152/MH152
16 900-2407 BIH252/MH252
17 900-2408 BIH352/MH352
18 900-2409 BIH452/MH452
* 200-6556 BIH552/MH552
Basket Hangers and Mounting Hardware
19 823-0782 Solid (old design)
20 823-1618 Solid (new design) for drop in probes
21 810-2793 Wire Form (with .330-inch mounting holes)
22 809-0171 Thumbscrew, ¼-20 x 1⅜-inch
23 809-0402 Thumbscrew, ¼-20 x ½-inch
24 826-1351 Nutsert, ¼-20 Square (for use on standard fluecap) (Pkg. of 10)
25 809-0535 T-Nut, ¼-20 x 7/16-inch (for use on Cap-N-Splash assembly)
26 809-0079 Nutsert, ¼-20 Round (for use on early-production Cap-N-Splash)
27 809-0921 Spacer, Basket Hanger
28 809-0989 Thumbscrew, ¼-20 x 1-inch
* Not illustrated.
NOTE: In August 2001, a design change required that all models above serial # 0108
replacing the Cap-N-Splash must also replace the topcap. The new topcap and Cap-N-
Splash are not interchangeable with the previous one.