FSI BM211 - Page 19

© 2021 Flanders Scientic, Inc.
19
Return to Table of Contents
Function Menu
Rec. Status Tally
This function is designed for use with cameras that output Start/Stop Record ags in the ancillary data of their serial digital
output. To activate this function set Rec. Status Tally to a function button and press that function button once. While active
the monitor’s red tally light will turn on when the Start Record SDI ag is detected and will turn the red tally light off when the
Stop Record SDI ag is detected.
PAP - Live Side by Side and Picture In Picture Viewing
On BM and CM series monitors (excluding CM-170W) corresponding controls can be found in the Video Menu to change
your PAP Secondary Input and PAP Mode, allowing you to select Picture In Picture, Picture And Picture (Side-By-Side
Monitoring), Picture On Picture, Vertical Split Screen, or Horizontal Split Screen. You can use the Variable Wipe function in
conjunction with the Vertical and Horizontal Split modes to set a custom split position other than the default of center screen.
As of rmware version 1.1.03-2144 you can page through the different PAP viewing modes using the up and down
arrow keys while the function is active.
Dual Link
CM & BM series units equipped with FSI’s second generation Color Fidelity Engine (CFE2) can support Dual Link SDI
(2 x 1.5Gpbs SDI) in addition to single link 3Gbps SDI for advanced signal format support. 3Gbps SDI is the preferred
connectivity method if available, but if single link 3Gbps SDI output from your source is not available you can use the Dual
Link function to activate Dual Link SDI support. To activate this capability rst select SDI 1 as your input. Then set Dual Link
to a function button. Then press that designated function button to turn on Dual Link mode. Once active you may need to set
your SDI format manually if no payload ID is present in the signal. To do this go to the SDI format section of the Video Menu
and select the appropriate format.
DIT LUT
Use to activate DIT (Look) LUTs stored to the monitor. Scroll between LUT positions using the monitor’s up and down keys.
See Appendix A for details on saving DIT (Look) LUTs to the monitor.