FSI BM211 - System Menu

© 2021 Flanders Scientic, Inc.
35
Return to Table of Contents
System Menu
Main Menu System
Function Load Prole
Scopes & Audio Meters Save Prole
Video Update Firmware
Audio Keypad LED Normal
Marker Chroma/Bright/Contrast Unlock
Alarm Luminance Interval On
OSD Udisk Mode On
GPI Language English
Color Management DHCP On
System IP Address 192.168.001.111
System Status Subnet Mask 255.255.255.0
Support RS422 Address 1
Baud Rate 9600
Parity None
Load Prole
Recall Saved Prole Settings. Highlight desired prole & press ENTER to activate the saved prole selection.
Save Prole
Saves all current monitor settings under a recallable prole by highlighting Prole number & pressing ENTER.
Update Firmware
As of rmware version 9.53-1907 or later UDisk mode enables your monitor to permanently remain in update mode.
When on you can simply plug your monitor into any compatible computer with the provided USB to RJ-45 update cable and
it will be recognized as a USB mass storage device for transfer of new rmware and/or 3D LUTs.
Use this to update rmware once your new rmware le has been loaded to the monitor.
Keypad LED
Allows you to turn off the LED lights on the Monitor’s Keypad. Select from Normal, All Off, and All On. In the default Normal
mode active keys will illuminate. In All Off mode, no keys will illuminate. In All On mode, all keys will stay illuminated and will
ash when activating or deactivating a function.
Chroma/Bright/Contrast
When set to Lock this option will lockout the Chroma, Brightness, & Contrast knobs to help prevent accidental adjustment.
Luminance Interval
The luminance interval is a power saving feature; It allows you to specify the amount of time without an active signal being
shown on the monitor that should be allowed to expire before the monitor’s backlight (if applicable) is turned off to reduce
the power consumption of the unit. When placed in the On position the monitor will not enter the power saving mode and
will keep the backlight on so long as the monitor is left on.
UDisk Mode
As of rmware version 9.53-1907 or later you can set this to ON, now the default, to allow your monitor to permanently
remain in update mode. When on you can simply plug your monitor into any compatible computer with the provided USB to
RJ-45 update cable and it will be recognized as a USB mass storage device for transfer of new rmware and/or LUTs. This
should only be turned OFF when using GPI control.