Fuji Electric FRENIC-Lift LM2C Series - Wiring; Removing the; Mounting the

2-2
2.2 Wiring
Follow the procedure below. In the following description, it is assumed that the inverter has already been
installed.
2.2.1 Removing the front cover
① Remove the keypad blind cover and loosen the screws
② Hold the right and left ends of the front cover and remove it.
Figure 2.2 Removing the Front Cover
(FRN0010LM2C-4E to FRN0032LM2C-4E)
2.2.2 Mounting the front cover
After wiring, mount the front cover back into place.
(Tightening torque: 1.8N･m)
Blind cover
Front cover
Screw
(FRN0010LM2C-4□toFRN0032LM2C-4□)