3-1
Chapter 3 OPERATION USING THE KEYPAD
The FRENIC-Lift has no standard keypad. Using the optional multi-function keypad allows you to start and stop
the motor, monitor running status, and switch to the menu mode. You may also set the function code data, monitor
I/O signal states, maintenance information, and alarm information.
Keypad is available to the following ROM versions.
Table 3.1 Keypad and ROM versions
Keypad ROM versions
TP-A1-LM2 8700 or later
TP-E1U
1600 or later
For details of the multi-function keypad, refer to the FRENIC-Lift LM2C series Reference Manual.
To Next Page
Loading...
