Fuji Electric FRENIC-Lift LM2C Series - Chapter 7 SPECIFICATIONS; Standard Model Specifications

7-1
Chapter 7 SPECIFICATIONS
7.1 Standard Model
1) Three-phase 400V series
10 15 19 25 32
4 5.5 7.5
11 15
7.6 11 14 18 24
21.4
(24.5)
*14
18 27 33.3 44.1 57.6
(3s) (3s)
(3s)
(3s)
(3s)
7.5
10.6
14.4 21.1
28.8
13 17.3 23.2 33 43.8
5.2 7.4 10 15 20
3.2 4.4
6.0 8.8 12
26
4.1 4.1 4.4 4.4 5.6
Variations
Heat sink
in
in standby
*13
Nominal applied motor [kW]
(Permissible overload time)
Rated frequency [Hz]
Required power supply
Phases,Voltage,Frequency
connected [W]
*6
Auxiliary control power supply Voltage
EMC filter
Cooling method
18.5
Item
Specifications
Type FRN___LM2C-4□
Overload capacity [A]
Rated current
*3
[A]
10
15
32
50, 60Hz
Input ratings
Main power supply
Normal
operation
Phases, Voltage, Frequency
Three-phase, 380 to 480V, 50/60Hz
Voltage: +10 to -15% (Voltage unbalance: 2% or
Frequency: +5 to -5%
Output ratings
Rated capacity
*1
[kVA]
Rated voltage
*2
[V]
Three-phase 380V-480V, 50/60Hz
Without DCR
with DCR
current
*5
[A]
Rated
Single-phase, 220 to 480V, 50/60Hz
180
Battery
operation
Power Supply Voltage for
driving
DC 48V or more in the direct
current voltage
conversion.
Operation time [s]
180
Variations
Voltage: +10 to -10% ,Frequency: +5 to -5%
Operation time [s]
UPS operation
DC 24V (22V to 32V) ,Maximum 40W
Braking
Braking time
*7
[s]
60
Braking duty-cycle (%ED)
*7
[%]
50
Rated regenerative power
*7
[kW]
47
24
Minimum resistance which can be
96
47
36
External (According to EN12015, EN12016)
Enclosure (IEC60529)
IP20
IP54
Weight/Mass [kg]
Average power losses
[W]
16
23
Fan cooling
Average sound pressure level
at trip.[dBA]
*8
44.5
48
49.5
*1) Rated capacity is calculated by regarding the output rated voltage as 440V .
*2) Output voltage cannot exceed the power supply voltage.
*3) These values correspond to the following conditions: carrier frequency is 8 kHz (2 phase modulation) and ambient
temperature is 45°C.
Select the inverter capacity such that the square average current during operation is not higher than the 80% of the
rated current of the inverter.
*4) Voltage unbalance [%] = (Max.voltage [V] - Min.voltage [V])/ Three-phase average voltage [V] x 67 (IEC61800-3)
*5) The power supply capacity is 500kVA (ten times the inverter capacity when the inverter capacity exceeds 50kVA), and
the value of the power supply impedance is %X=5%.
*6) The admissible error of minimum resistance is ±5%.