Fuji Electric FRENIC-Lift LM2C Series - Page 41

5-2
Table 5.1 Quick List of Alarm Codes（Continued）
Code
Name
Description
Ert CANopen communication error
A communications error has occurred during CANopen
communication.
bbE Brake confirmation
The inverter detects mismatch between the brake control
signal and brake detection (feedback) signal.
tCA Reaching maximum numbers of trip counter
The number of trip direction changes has reached the
preset level.
nrb NTC wire break error
Detected a wire break in the NTC thermistor detection
circuit.
ECL Customizable logic error
A customizable logic configuration error has caused an
alarm.
Eo EN1, EN2 terminals chattering
Detected collision between ENOFF output and EN1/EN2
input terminals.
ECF EN1, EN2 terminals circuit error
An abnormality was diagnosed in EN1, EN2 terminals
circuit.
* These alarms can change enable/disable by a function code.

For detail of function code refer to the FRENIC-Lift LM2C series Reference Manual.