E99 as listed below.
Terminal [REV] Function
0 (1000): Select multistep frequency
1 (1001): Select multistep frequency
2 (1002): Select multistep frequency
3 (1003): Select multistep frequency
4 (1004): Select ACC/DEC time
6 (1006): Enable 3-wire operation
7 (1007): Coast to stop
8 (1008): Reset alarm
9 (1009): Enable external alarm trip
10 (1010): Ready for jogging
11 (1011): Switch frequency command 2/1
12 (1012): Select Motor 2 / Motor1
13 : Enable DC braking
14: (1014): Select Torque Limiter Level
17 (1017): UP (Increase output frequency)
18 (1018): DOWN (Decrease output frequency)
19 (1019): Enable write from keypad (Data changeable)
20 (1020): Cancel PID control
21 (1021): Switch normal/inverse operation
24 (1024): Enable communications link via RS485 or field bus (option)
25 (1025): Universal DI
26 (1026): Enable auto-search at starting
27 (1027): Speed feedback control switch
30 (1030): Force to stop
33 (1033): Reset PID integral and differential components
34 (1034): Hold PID integral component
42 (1042): Position Control limit switch
43 (1043): Position Control start/reset command
44 (1044): Switch to the serial pulse receiving mode
45 (1045): Enter position control return mode
46 (1046): Overload stopping effective command
98 : RUN forward
99 : RUN reverse
Setting the value of 1000s in parentheses () shown below assigns a
negative logic input to a terminal.
Note: In the case of THR a Stop, data (1009) and (1030) are for normal
logic, and “9” and “30” are for negative logic, respectively.
[SS1]
[SS2]
[SS4]
[SS8]
[RT2/RT1]
[HLD]
[BX]
[RST]
[THR]
[JOG]
[Hz2/Hz1]
[M2/M1]
[DCBRK]
[TL2/TL1]
[UP]
[DOWN]
[WE-KP]
[Hz/PID]
[IVS]
[LE]
[U-DI]
[STM]
[PG/HZ]
[STOP]
[PID-RST]
[PID-HLD]
[LS]
[S/R]
[SPRM]
[RTN]
[OLS]
[FWD]
[REV]
99
To Next Page
Loading...
