3-8 1. Error Messages
Item Name
The item name indicates the screen or other locations where the error was detected.
Sub-item Number
The sub-item number indicates the number of the screen where the error was detected.
• Logging server/alarm server: 0 to 11 = block No.
• Message: Message group No.
• For graphic library, the following library numbers are shown.
Graphic group No. 256 + No. in the group
• Device memory map: xyy (x = PLC1 to 8, yy = table No.)
• I/F driver: 1 to 8 = PLC1 to 8, 9 = simulator
310 An alarm type is not specified for the alarm
server.
Check the alarm type setting of monitored
alarms for the relevant alarm block number at
[System Setting] [Alarm Server].
Error No. Contents Solution
To Next Page
Loading...