2-64 2. Local Mode Screen
16-4. Deleting Data from Storage
This section explains how to delete data from an SD card inserted into the SD card slot on the V9
series unit.
1. SD card insertion
Insert an SD card into the SD card slot on the back of the MONITOUCH.
For details, refer to page 2-57.
2. Storage Transfer screen display
Switch to Local mode and press [Storage Transfer] in the menu icons.
The Storage Transfer screen is displayed.
* Do not remove and reinsert the SD card from this point on.
3. Target storage device and data selection
Select [[C:] SD Card] under [Storage to Connect].
4. Transfer operation selection
Select [Delete] in the [Transfer Menu] and press the [OK] switch.
The confirmation dialog shown below is displayed.
5. Execution of data delete to during execution
Press the [OK] switch if deleting all data from storage.
The switch is lit for a while.
6. Data deletion completed
When the data has been completely deleted, the message “Work normally finished.” is displayed.
Data is completely deleted.
Execution of data deletion During execution
To Next Page
Loading...