Fuji Electric Monitouch V9 Series - WLAN Setting (Only for Wireless LAN I;F Models)

2
2. Local Mode Screen 2-23
Local Mode Screen
6. WLAN Setting (Only for Wireless LAN I/F Models)
Pressing [WLAN Setting] in the menu icons brings up the WLAN Setting screen.
This screen is used to configure wireless LAN settings for the V9 series unit.
* For details on general specifications and conformance standards for wireless LAN, refer to the V9
Series Hardware Specifications manual.
When the wireless LAN link is not established *, the [WLAN Setting] switch in the menu icons is
changed as follows.
* A link is not established in the following states.
- The wireless LAN is turned off (disabled).
- The wireless LAN is turned on (enabled) but a link is not established.
- The wireless LAN is turned on (enabled) but not connected to the specified access point.
Item Description
Apply
Press the [Apply] switch on the WLAN Setting screen to save the settings on the [IP
Setting], [Wireless Settings] and [Wireless Option] tab windows.
To save settings on the [Select AP to Connect] tab window, be sure to press the [Apply]
switch in the [Select AP to Connect] tab window.
Menu icons WLAN Setting screen
Link established Link not established
WLAN Setting screen