2
2. Local Mode Screen 2-13
Local Mode Screen
4-1. IP Setting
The [IP Setting] tab window on the LAN Setting screen allows you to set or change the IP address
setting of the V9 series unit.
*1 For details on the setting items, refer to page 2-16.
*2 Used for macro commands of EREAD, EWRITE, SEND and MES as well as Ethernet DLL functions.
[IP Setting] tab window
After changing the setting,
press the [Apply] switch to
confirm the setting.
Pressing each setting field
brings up the system
keyboard to be used for
configuration.
Pressing each setting field
brings up the system
keyboard to be used for
configuration.
Item Description
IP Address
*1
Set the IP address for the V9 series unit.
(Default: 192.168.0.1)
Subnet Mask
*1
Set the subnet mask.
Gateway
*1
Set the default gateway.
* If a gateway is not used, leave this field blank.
(Do not use “0.0.0.0”.)
MAC Address Indicates the MAC address of the V9 series unit.
External Access
Service Port
*1 *2
Set a port number of the V9 series unit (1024 to 65535).
(“8001” is not available.)
Time-Out
*2
Set the timeout time.
Retrials
0 to 255
Set the number of retries to be performed when a timeout occurs.
Network Table
When a network table setting is set in the screen program, the
contents of the network table are displayed.
Tap an IP address to select from the network table.
• Set an IP address in a different network group from that for the following:
- [LAN Setting] / [LAN2 Setting] (only for additional wired LAN I/F models)
- [WLAN Setting] (only for wireless LAN I/F models)
- [LAN Unit Setting] (only with the CUR-03 communication I/F unit installed)
If set in the same network group, the system will not operate correctly.
• Set a gateway for only one of the following:
- [LAN Setting] / [LAN2 Setting] (only for additional wired LAN I/F models)
- [WLAN Setting] (only for wireless LAN I/F models)
- [LAN Unit Setting] (only with the CUR-03 communication I/F unit installed)
If multiple gateways are set, the system will not operate correctly.
To Next Page
Loading...