1-24 4. Status Bar
VPN Connection Status
This icon is shown when VPN connection is enabled.
When VPN connection is disabled, the icon disappears.
When the VPN connection status icon is pressed during connection, the following confirmation dialog
appears.
Press the [Unlink] switch to disconnect from the VPN.
When the VPN connection status icon is pressed when disconnected from the VPN, the following
confirmation dialog appears.
Press the [Connect] switch to allocate an IP address for VPN connection and connect to the VPN.
* For details on VPN connection, refer to the separately provided “Web Machine Interface” manual.
Connected VPN connection disabledDisconnected
The IP address allocated to
the V9 series unit for VPN
connection
To Next Page
Loading...