3-16 2. Troubleshooting
The system menu cannot be
displayed in RUN mode.
• For Advanced models
Any of the following parts are placed in
the corners of the screen.
Switches, data display parts with
switches, display areas, slider switches,
scroll bars, and table data display parts
The display area of a scrolling message
part is in the corner of the screen.
• For Standard/Lite models
The [SYSTEM] switch is prohibited.
• For Advanced models
Be sure to press a corner where none of
the items given on the left are placed.
If items are placed in all four corners of
the screen, switch the screen to one that
has open corners and perform the
procedure to display the system menu.
• For Standard/Lite models
To enable the [SYSTEM] switch, hold
down the [F7] switch with the [SYSTEM]
switch for the time specified for
[Change-over Time] (max. 30 seconds).
([Change-over Time] is set in the screen
program.)
The RUN mode cannot be
switched to Local mode even by
pressing the [Local] switch on the
system menu.
The changeover time is specified in the
screen program.
Hold down the [Local] switch on the system
menu for the specified changeover time
(max. 30 seconds).
(Only on Standard/Lite Models)
The [Local] switch is not
displayed on the system menu
displayed in RUN mode.
[Mode Switch Prohibited] is selected. Hold down the [F1] switch with the [F7]
switch for the time specified for [Change-over
Time] (max. 30 seconds). ([Change-over
Time] is set in the screen program.)
The status bar cannot be
displayed in RUN mode.
[Status Bar Prohibited] is selected. Deselect [Status Bar Prohibited] in the
[System Setting] [Unit Setting]
[System/Mode Switch] tab window in V-SFT
version 6.
The message “Battery
changeover required” is
displayed in Local mode.
1) The time to replace the battery is
approaching.
2) No battery is set.
1) Replace the battery with a new one by
referring to the V9 Series Hardware
Specifications manual.
2) Data in the SRAM area or built-in clock
data cannot be retained unless power is
supplied.
Refer to the V9 Series Hardware
Specifications manual and set a battery.
Symptoms Causes Solutions
To Next Page
Loading...