Fuji Electric Monitouch V9 Series - Page 56

2
2. Local Mode Screen 2-15
Local Mode Screen
Setting Using the V-SFT Editor
1. Select [System Setting]  [Ethernet Communication]  [Local Port Address] on V-SFT.
The [IP Address Setting] window is displayed.
2. Select the [Set IP] checkbox in the [LAN] tab window, and set each item.
* For details on the setting items, refer to page 2-16.
3. Click [OK].
4. Transfer the screen program to the V9 series unit.
5. Select the [Restore Screen Data Settings] switch in the [LAN Setting]  [IP Setting] tab window in
Local mode, and press the [Apply] switch.
6. Select [System Information]  [MONITOUCH Information], and check the contents in the
[Ethernet Information] field.
Select IP Address from
Network Table
This is valid when the IP address of the V9 series unit has been
registered in the network table. Select a network table number from 0 to
255 to set the IP address.
IP Address
*
Set the IP address for the V9 series unit.
Default Gateway
*
Set the default gateway.
Subnet Mask
*
Set the subnet mask.
When this box is not checked, the subnet mask is automatically assigned
based on the first octet of the IP address.
Example:
IP address 172.16.200.185: “255.255.0.0” is set.
IP address 192.168.1.185: “255.255.255.0” is set.
Port No.
*
Set a port number from 1024 to 65535.
(“8001” is not available.)
Send Timeout
Set a timeout period for transmitting macro commands EREAD,
EWRITE, SEND, MES or Ethernet DLL functions.
Retrials
0 to 255
Set the number of retries to be performed when a timeout occurs.
Device Protect
Internal Device
Memory Card Device
Select these checkboxes to write-protect the corresponding device
memory from PCs or other stations.