2-18 2. Local Mode Screen
4. Press the [Apply] switch to confirm the settings.
Adding a Network Table
1. Press [LAN Setting] in the menu icons and open the [Network Table Edit] tab window.
2. Press the [Add] switch.
3. Press each item and input settings using the system keyboard. Then press the [Confirm] switch.
* Be sure to register a network table number.
When the [Select IP Address from Network Table] checkbox is selected and a network table number
is specified at [System Setting] [Ethernet Communication] [Local Port Address], any attempt to
modify the settings of the specified network table number from the V9 unit will not be reflected to the
local port address settings ([IP Setting] tab window).
If a gateway is not used, leave the field blank.
To Next Page
Loading...