Fuji Electric NP1L-RS1 - Loader Connecting Cable; When Connecting to RS-232 C Port; When Connecting to RS-485 Port

3-9
3-3 Loader Connecting Cable
Loader connecting
To connect a D300win personal computer loader to the RS-232C or RS-485 port of the general purpose communication
module, the cable must be connected in the following manner.
3-3-1 When connecting to RS-232C port
Because the RS-232C connector of the general purpose communication module is “female,” attach the male connector
onto the cable connector for the general purpose communication module, as shown in the figure below:
9-pin D-sub connector (male) 9-pin D-sub connector (female.)
General purpose communication module side Personal computer side
CD
RD
SD
ER
SG
DR
RS
CS
RI
CD
RD
SD
ER
SG
DR
RS
CS
RI
1)
2)
3)
4)
5)
6)
7)
8)
9)
1)
2)
3)
4)
5)
6)
7)
8)
9)
3-3-2 When connecting to RS-485 port
Because the RS-485 connector of the general purpose communication module is “male,” attach the female connector onto
the cable connector for the general purpose communication module, as shown in the figure below:
9-pin D-sub connector (female) 9-pin D-sub connector (female)
General purpose communication module Personal computer side
RX-
RX+
TX-
TX+
For conversion from RS-232C to RS-485
port on personal computer, use a
commercially available converter.
RS-485/RS-232C converter
SDB
SDA
(SDB)
(SDA)
SG
FG
RDB
RDA
CD
RD
SD
ER
SG
DR
RS
CS
RI
1)
2)
3)
4)
5)
6)
7)
8)
9)
1)
2)
3)
4)
5)
6)
7)
8)
9)