App.2-7
Appendix 2-3 Loader Command Details
Appendix 2-3-3 Batch Start of CPUs
1) Function
This command activates all the CPUs in the configuration at one time.
Each CPU cold-starts or warm-starts depending on the condition. CPUs already activated or CPUs with the key switch set
to the “RUN” position do not perform any processing. They respond normally without error.
2) Command/mode code
Command: 04h, Mode: 00h
3) Data format of request command/response command
None
4) Batch start command of CPUs
When activating all the CPUs at one time, request and response commands are as shown below.
Request command : FF7A0000110000000000040000010000
Response command : 007A0000110000000000040000010000
Appendix 2-3-4 Batch Initialization Start of CPUs
1) Function
This command initializes and activates all the CPUs in the configuration at one time.
Each CPU cold-starts. CPUs already activated or CPUs with the key switch set to the “RUN” position do not perform any
processing. They respond normally without error.
2) Command/mode code
Command: 04h, Mode: 01h
3) Data format of request command/response command
None
4) Batch initialization start command of CPUs
When initializing and activating all the CPUs at one time, request and response commands are as shown below.
Request command : FF7A0000110000000000040100010000
Response command : 007A0000110000000000040100010000
Appendix 2-3-5 Batch Stop of CPUs
1) Function
This command deactivates all the CPUs in the configuration at one time.
CPUs already activated or CPUs with the key switch set to the “RUN” position do not perform any processing. They
respond normally without error.
2) Command/mode code
Command: 04h, Mode: 02h
3) Data format of request command/response command
None
4) Batch stop loader command of CPUs
When deactivating all the CPUs at one time, request and response commands are as shown below.
Request command : FF7A0000110000000000040200010000
Response command : 007A0000110000000000040200010000
To Next Page
Loading...
