Fuji Electric NP1L-RS1 - Page 76

App.2-3
Appendix 2-2 Send Data Format of Commands
< Status list >
edoC sutatS noitpircseD
h00dnelamroN .detelpmocyllamronsignissecorpdnammoC
h01rorreUPC .detucexeebtonnacdnammocdnadeliafUPCehT
h11gnitareposiUPC .gnitareposiUPCehtesuacebdnammocetucexetonnaC
h21elbissoptonnoitucexednammoC .noitidnochctiwsyekUPCfoesuacebdnammocetucexetonnaC
h02dnammocdenifednU .edomrodnammocdenifednunadeviecerUPCehT
h22rorreretemaraP .noitacificepsgnorwasniatnocredaehdnammocehT
h32dekcolretninoissimsnarT .ecivedrehtomorfdnammocredaolaybdekcolretnisinoissimsnarT
h82ssergorpnignissecorpdnammoC .dnammoctseuqerehtetucexetonnaC.dnammocrehtognissecorP
hB2ssergorpnignissecorpredaolrehtO .dnammoctseuqerehtetucexetonnaC.redaolniw003DehtgnissecorP
hF2detelpmoctonnoitazilaitinI .dnammoctseuqerehtetucexetonnaC.ssergorpninoitazilaitinimetsyS
h04rorrenoitacificepsataD .deificepssawrebmun/epytataddilavninA
h14dnuoftonataddeificepS .tsixetonseodataddeificepsehT
h44rorrenoitacificepssserddayromeM .egnardilavehtfotuosisserddadeificepsehT
h54dedeecxeezisyromeM .egnardilavehtsdeecxesdrowetirw/daerdnasesserddaforebmunehT
h0ArorrenoitacificepstegratdnammoC .eludomondengissasirebmunnoitatstegratdeificepsehT
h2AesnopserdnammocoN .eludomtegratehtmorfatadesnopseroN
h4ArorrednessubXS .sdnammoceviecerrodnestonnaC.subXSehtnoderruccororrenA
h5AKANdnessubXS .sdnammoceviecerrodnestonnaC.subXSehtnoderruccoKANA
hFFdeificepssidnammoc-tseuqerehtnehW
4) Target module specification, connection ID
Specifies the target module.
eludomtegraT edomnoitcennoC )L(DInoitcennoC )H(DInoitcennoC
0UPChA7h00h00
7UPCot1UPChB7UPCtegratehtrofrebmunnoitatssubXSh00
ten-LFknilEP/PhB7eludomtegratehtrofrebmunnoitatssubXSh00
5) Command, mode
Command: Major category code of commands
Mode: Detailed code of commands
For details on commands and modes, refer to “Appendix 2-3 Loader Command Details.”
6) Number of bytes in data
Indicates the number of bytes in data. The total number of bytes in the request command during data write operation and
the response command during data read operation must not exceed 492 bytes.
7) BCC (block check character)
Checksum code for send data check. The BCC, consisting of one byte, is obtained by the following expression:
BCC = 00h- { ( Data counter ) + ( Connection status) + + ( Data ) }