5 Scan
308
Scan
5
z
Server Name / IP address
z
Shared Name (SMB Only)
z
Save in
z
User Name
z
Password
z
Port Number
Note • To delete the input data and return to the [Server Address Book] screen, select [Cancel].
For more information on the setting items, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator
Guide.
11 When the settings are completed, select [Registered].
Note • To return to the previous screen, press the [Back] button.
Specifying a Destination PC Using a One Touch Button
You can use the one touch buttons to specify the server name, the user name used for
logging in to the destination server or other computers, and other information from the
Address Book.
One touch buttons correspond to the address numbers from 0001 to 0070, or 0001 to 0060.
For example, when the number you want to dial is registered to the address number 0001,
press one touch button <1>.
Note • One touch buttons can be used when the Fax service is available.
• There are two ways in which address numbers and stored programs are assigned to the one touch
buttons. Select either of the following. By default, [Type 1] is selected.
-[Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered address
numbers 0001 to 0070, while the buttons M01 and M02 are used for stored programs and
correspond to the registered stored programs 1 and 2.
-[Type 2]
The buttons 1 to 60 are used for address numbers and they correspond to the registered address
numbers 0001 to 0060, while the buttons 61 to 70, M01 and M02 are used for stored programs
and correspond to the registered stored programs 1 to 12.
1 Press a one touch button. Confirm that the
recipient (destination PC) specified with the
one touch button is displayed on the touch
screen.
Important • The one touch buttons have a sensor to
detect which page of one touch buttons (1 -
24, 25 - 48, and 49 - M02) is currently
opened. Before pressing a one touch button,
turn over the one touch panel completely,
and take off your hand from the panel. Do
not press the button while you are turning
over the panel.
• Do not place any objects near the one touch
buttons, nor spill any liquid over them.
Note • Turn the one touch panel over to press the
one touch buttons 25 and above.
• If you have entered an incorrect value, select the recipient (destination PC) displayed on the touch
screen, select [Remove] on the pop-up menu, and enter the correct value.
To Next Page
Loading...
Need help?
General
