Copying Procedure
77
Copy
3
For information on how to copy mixed sized documents, refer to "Mixed Size Originals (Scanning Different Size Documents
Simultaneously)" (P.116).
1 Remove any paper clips and staples before loading a document.
2 Load the document face up (when the
document is 2-sided, load the front side up) in
the center of the document feeder.
Note • The Confirmation indicator lights up when
the document is loaded correctly. If the
indicator does not light, load the document
again.
3 Adjust the document guides to match the size
of the document loaded.
4 Open the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with a size
up to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard document size,
refer to "Original Size (Specifying the Scan Size for the Document)" (P.115).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on the paper size settings, refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
Do not apply excessive force to hold thick document on the document glass. It may break
the glass and cause injuries.
To Next Page
Loading...
Need help?
General
