Fax
4
4 Fax
208
îš„Fax Signal Method
This method employs a Fuji Xerox proprietary communication procedure that is only for
use with specific machines that have the Relay Broadcast feature.
îš„DTMF Method
G3 fax machines that support Manual Send can perform Relay Broadcast for the
machine.
îš„F Code Method
This method can be used among machines that support the F Code and the Relay
Broadcast features.
Before using the Relay Broadcast Feature
Before using the Relay Broadcast feature, register the following information.
For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
For information on the setting items to be registered in relay stations, refer to the documentation
provided with relay stations.
Fax Signal Method
1 Select an address number or group dial number to which a relay broadcast is
registered, and press the <Start> button.
To perform Multiple Relay Broadcast, repeat this step.
DTMF Method
The following two types are available in the DTMF method: Auto Send and Manual
Send.
îš„Auto Send (Transmitting without picking up the receiver)
1 Select [New Recipients] to display the keyboard on the touch screen and enter in the
following format.
z
Password
A pre-registered 2-digit number
Where Contents
Initiating
Station
Fax Signal Method
Assign the relay station to an address number (0001 to 2000) to set up the
Relay Broadcast feature.
z
Register the last two digits of the address number of the initiating station
(which is already registered at a relay station) as a relay station ID for the
Relay Broadcast operation.
z
Register the address numbers or group dial number of the relay recipients
(which are registered at a relay station) as broadcast recipients. The wildcard
"∗" can be used.
DTMF Method (G3)/F Code Method
z
No registration is required. The dialing format can be registered to an address
number.
To Next Page
Loading...
Need help?
General
