Broadcast
209
Fax
4
Note • By default, no password is set. For setting a password, contact our Customer Support
Center. If a password is not set, you do not need to enter one.
z
Relay station ID
The last two digits of the initiating station address number registered at the relay
station
z
Address number
An address number for the relay recipients registered at the relay station
The wildcard "∗" can also be used.
You can register the above dialing format in an address number to send using the address number. For
information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
2 Select [+ Add] to perform Multiple Relay Broadcast.
Note • You can specify up to 20 locations for relay recipients.
3 Press the <Start> button.
îš„Manual Send (Transmitting with picking up the receiver or on-hook)
1 Select the [More Options] tab to display the [More Options] screen.
2 Pick up the telephone receiver, or select
[On-hook (Manual Send/Receive).
3 Select [Manual Send] from the drop-down
menu.
4 Use the keyboard displayed on the touch screen to enter numbers in the following
format.
Note • You can specify up to 20 locations for relay recipients.
F Code Method
You can perform Relay Broadcast by registering the relay station’s F code and
password (if necessary) to the machine.
Note • When performing Relay Broadcast with the F Code method, you can use a password if you
set a receive password for the relay station.
• When performing Relay Broadcast between Fuji Xerox manufactured machines that can be
used as both an initiating station and a relay station, we recommend that you use the fax
signal method.
• Confirm the F code (sub-address) and password of the target relay station.
To Next Page
Loading...
Need help?
General
