Fuji Xerox DocuCentre 9000 - Interface Cables; Using USB Interface; Using Ethernet Interface

Interface Cables
23
Product Overview
2
Interface Cables
When connecting this machine directly to a computer, use USB interface. When
connecting to a network, use the Ethernet interface.
Using USB Interface
The USB interface (optional) supports USB2.0.
This section describes the installation procedure for the USB interface.
1 Confirm that the power switch is
turned off.
2 Connect a USB interface cable to
the USB2.0 interface connector on
the rear of the machine.
3 Connect the other end of the USB
interface cable to the computer.
4 Switch on the machine.
5 Restart the computer.
For details of setting items, refer to "Installation When Using the USB Port (P.29)".
Using Ethernet Interface
The Ethernet interface supports the following 2 types.
z
100BASE-TX
z
10BASE-T
This section describes the installation procedure for the Ethernet interface.
1 Confirm that the power switch is
turned off.
2 Connect a network cable to the
Ethernet interface connector.
Note • Prepare a network cable
suitable for your network
connection. When changing
the network cable, consult our
customer engineers.
3 Switch on the machine.